Of Wings and Things

I did some work on the wings last night. I used the existing wings as a template to cut out new wing tops and bottoms and to mark where I'll scribe panel lines. I found some strip styrene in my stash that I'll use as spacers between the upper and lower sections.


Finished up with the engine (I think) and got a starter resin casting kit. Once back from camping, I'll give it a go.
I may not get much done next week, I'm preparing for a week of aviation overload..Airventure in Oshkosh Wisconsin.

Comments

Post a Comment

Popular posts from this blog

Making the Cockpit

Image
I started on making the cockpit by taking measurements and making templates out of paper. After a lot of trial and error I came up with a configuration that looked good and fit within the upper half of the fuselage. I transferred the templates to .20 styrene. I used several photos of the cockpit as reference. I had originally wanted angles side panels but later went with flat panels and then added buttons and drilled holes for the fiber optics. With the basic cockpit layout complete it was on with painting and running the fiber.
Read more

A Not So Long Time Ago

Image
Hi; I'm in the process of converting a Hasbro X-Wing toy into a model. I started the project 6 months ago but only now decided to make this blog to document the build. So I'll bring you up to speed on the project. I bought the X-wing just before Christmas with the thought of converting it to a scale model. I spent some time deciding exactly what I was going to do for the conversion. Since it has no cockpit I wanted to add one, which meant cutting out the windows and then building a cockpit. I'll add photos of that part of the build. The cannons and engines were another area that needed rebuilding. The underside of these areas are hollow which will mean making new engines and cannons. I also wanted to add lights to the cockpit, the engines and the landing lights. So I'll be documenting that as well in upcoming posts.
Read more
Image
I've made steady progress on the wings, scoring panel lines and making the details for the interior sections.  I finally got the vacuform machine working and pulled several copies of the engine interior. I had to use .010 sheet styrene to make these copies. Not perfect but very usable. I tried using the plastic "No Trespassing " signs but their to thick and I couldn't get a good pull. Now I can start to greeble these things up. Onward.
Read more